Hello, I have a WD Sentinel DX4000 12TB unit and it’s recently been locking up.
After talking to WD Help they recommended I ‘Perform a Recovery’.
However every time I get to the last stage I get the error message ‘Error Code: 0x8007000d’
-------------------------------------
Recover your server
Could not reset the server to factory default settings
Your server was not reset to the factory default settings. Resolve the issue, and then restart the server recovery process.
Error Code: 0x8007000d
------------------------------------
On the drive its says 'Recovery Started' but no progress number.
This drive has 9 years of my life on it and I am just a bit panicked.
Any help much appreciated,
Thor