Hi all!
Recently had a portable had disk failure that I use in my backup routine, so then had to add a new one into the cycle by using Powershell (as the stupid interface has that bug where you can't run the wizard if not all of the target disks are attached - nice one Microsoft!!)
Anyway, i digress ...I have successfully added the drive, but was not at any point given the option to give a name/label to the disk. When I originally configured the backup through the GUI, I could label all the disks (Monday, Tuesday ...etc...) so they could be easily identifiable through the GUI when having to restore etc...
So, my question is: can I use Powershell to rename the Label of the backup target retrospectively? ...or is there a "Label Parameter" that I can use when adding the target disk via Powershell?
Many thanks :)
Dug.
ps: my OS is SBS2011 if required - I hear that there is finally a hotfix for this issue, but only for 2012 ...took long enough!!